Advertisement
CLEANING THE COFFEE SERVER
1. In a container, mix a mild detergent and warm water solution for cleaning the
coffee server.
2. Discard old coffee from the coffee server.
3. Remove and clean the lid.
4. Clean inside the coffee server with a sponge brush soaked in detergent solution.
5. An easy way to remove mineral deposits from the brew cone and the coffee
server is to use a pouch or tablet cleaner.
a. Place two tablets or one pouch (refer to manufacturers' recommendation) into the
brew cone.
b. Place the empty coffee server onto the brew deck.
c. Start a coffee brew cycle by pressing the Brew button on the electronic controller.
d. When the brew cycle has finished, allow the cleaning solution to sit in the coffee server for a
few minutes, then empty the coffee server.
6. Wipe the exterior surfaces with a sponge moistened with the detergent solution. Wipe off coffee
spots or stains.
7. Rinse the brew cone and coffee server with running water.
8. Dry the parts and return them to the coffee brewer.
TFT LID – The TFT timer has a stem sensor that is built into the lid. Keeping this stem section
free from coffee oil build-up ensures that accurate time and volume information is displayed.
1. Before each brew cycle, wipe the stem clean.
2. After cleaning, invert the lid for 30 seconds. This will reset the timer.
3. Replace the lid onto the server. The unit is ready to use.
Recycle – Do not dispose in trash. The FreshTrac timer is considered an electronic device that can be recy-
cled. Recycling raw materials from end-of-life electronics is the most effective solution to the growing e-waste
problem. Many municipalities have created drop-off locations to help with e-waste issues.
WARNING – TO AVOID DAMAGE AND INJURY
•
DO NOT IMMERSE.
•
WASH BEFORE USING.
•
DO NOT BOIL LIQUIDS IN SERVER.
•
DO NOT HEAT SERVER ON WARMER.
Product Warranty Information
The Wilbur Curtis Company certifies that its products are free from defects in material and workmanship under normal use. The fol-
lowing limited warranties and conditions apply:
1 Year from the Original Date of Purchase.
RETURN MERCHANDISE AUTHORIZATION: All claims under this warranty must be submitted to the Wilbur Curtis Company Tech-
nical Support Department prior to performing any repair work or return of this equipment to the factory. All returned equipment must
be repackaged properly in the original carton. No units will be accepted if they are damaged in transit due to improper packaging.
NO UNITS OR PARTS WILL BE ACCEPTED WITHOUT A RETURN MERCHANDISE AUTHORIZATION (RMA). RMA NUMBER
MUST BE MARKED ON THE CARTON OR SHIPPING LABEL. All in-warranty service calls must be performed by an authorized
service agent. Call the Wilbur Curtis Technical Support Department to find an agent near you.
ECN 16219 . 10/16/14 @ 10.8 . rev C
ECN 15751 . 3/24/14@10.3 . revB
WILBUR CURTIS CO., INC.
ECN 15456 . 11/6/13@12/3 . rev A
6913 Acco St., Montebello, CA 90640-5403 USA Phone: 800/421-6150
EDR 8907 . 9/24/13@12.0 . rev NC
Technical Support Phone: 800/995-0417 (M-F 5:30A - 4:00P PST)
2
•
DO NOT USE ON RANGE TOP OF ANY KIND.
•
DO NOT PLACE IN DISHWASHER.
•
DO NOT DROP.
•
DO NOT POUR TOWARDS PEOPLE.
Fax: 323-837-2410
E-Mail: techsupport@wilburcurtis.com
Printed in U.S.A.
10/2014
F-3959 Rev C
Advertisement
