SHERCO 2014 250 SEF-R Workshop Manual page 37

•
Install the special tool that locks the Install the special tool that locks the
engine at top dead center (ref 1819). engine at top dead center (ref 1819).
•
Use tool 1817 to block the transmission Use tool 1817 to block the transmission
ant to tighten balancer nut.
Torque Torque of of balancer balancer
threadlocker.
•
Install the oil pump drive roll pin Install the oil pump drive roll pin, the
intern rotor and fixing nut to the cover fixing nut to the cover.
Torque of the oil pump cover : 5 Nm. Torque of the oil pump cover
•
Heat the crankshaft spacer ring (ref Heat the crankshaft spacer ring (ref
1732) to approximately 70 degrees and 1732) to approximately 70 degrees and install it
on the crankshaft.
•
Replace the freewheel assembly and the Replace the freewheel assembly and the
starter drive gear train (see the paragraph on starter drive gear train (see the paragraph on
disassembling the left side).
•
Reinstall the starter.
•
Reinstall the motor top end (see the Reinstall the motor top end (see the
paragraph on the top end).
•
Install the cam drive Install the cam drive chain (see the
paragraph on top end).
•
Install the clutch (see the paragraph on Install the clutch (see the paragraph on
disassembling the right side).
•
Install the clutch cover.
•
Install the spark plug.
Torque the spark plug to: 15 Nm. Torque the spark plug to: 15 Nm.
Apply threadlocker to all of the internal
engine threads except the five clutch pressure
plate fixing screws.
nut nut 60 60
to all of the internal
ept the five clutch pressure
Nm Nm +
37/75