SHERCO 2014 250 SEF-R Workshop Manual page 35

Reassembling the central crankcase assembly: Reassembling the central crankcase assembly:
During the rebuild, replace all seals ring the rebuild, replace all seals
(paper, seal, o-ring...).
•
Install Install the the
balancer assembly in the left case, align the balancer assembly in the left case, align the
marks as shown.
•
Install the transmission gear along with Install the transmission gear along with
their corresponding shafts.
•
Install a new roller on each shift fork.
•
Install the shift forks in the transmission Install the shift forks in the transmission
in their respective grooves.
•
Install the gear selector drum. Install the gear selector drum.
•
Place the shift fork rollers in their Place the shift fork rollers in their
respective grooves in the drum. respective grooves in the drum.
•
Install the shift fork shafts. Install the shift fork shafts.
The center shift fork shaft is the smallest The center shift fork shaft
in diameter.
Do not forget to lubricate all of the rotating Do not forget to lubricate all of the rotating
and sliding parts.
•
Replace the two locating dowels in the Replace the two locating dowels in the
case and install the washer on the transmission case and install the washer on the transmission
secondary shaft.
crankshaft crankshaft and and
on each shift fork.
counter counter
35/75