Appliance Break-In; Heat Management - Heat & Glo TIARAI-BK-IPI Owner's Manual

F. Appliance Break-In
Initial Break-in Procedure
• The stove should be run three to four hours continuously
on high.
• Turn the stove off and allow it to completely cool.
• Remove fixed glass assembly. See Section 4.B.
• Clean fixed glass assembly. See Section 4.
• Replace the fixed glass assembly and run continuously on
high an additional 12 hours.
This cures the materials used to manufacture the stove.
NOTICE! Open windows for air circulation during stove
break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
G. Heat Management
Heat Output
This model has a variable burn rate which is controlled by
the HI/LO switch on the control module. Therefore the flame
height is adjustable. The HI/LO switch is shown in Figure
3.3. It is located in the control cavity of the appliance.
If a remote control is installed, the flame height may also be
controlled by the remote, if flame height is a function of that
particular model of remote control.
If an optional fan is installed, the fan speed is controlled by
adjusting the speed control knob. Turn the knob clockwise
to increase the fan speed and counterclockwise to decrease
the fan speed.
SPEED CONTROL KNOB
ON/OFF SWITCH
Figure 3.3
10 Heat & Glo • TIARAI-BK-IPI, TIARAI-BR-IPI, TIARAI-CES-IPI Owner's Manual • 2342-981_R11 • 08/15