Led Indications - Bang & Olufsen Beolab transmitter 1 Installation Manual

LED indications

Power Link LED indications
WIRELESS LED indications
Product Status LED indications
Product Status LED and WIRELESS LED indications simultaneously
(See page 4 and page 16)
White ~ left speaker Red ~ right speaker
Off
On
Flashing
(See page 4)
State Signal
Configured wirelessly -
Standby Off
Normal operation White (solid)
Normal operation White (slow flashing)
Connecting Green (fast flashing)
Network strength is low Orange (solid)
Network failure Orange (fast flashing)
(See page 4)
State Signal
Power Link Transmitter 1 is Off -
Standby Off
Normal operation Off
Mains On and Red (solid)
Restart after Reset
Turning Off (go to Standby) Red (solid)
Turning On Green (solid)
Software Update Green (slow flashing)
Product failure Orange (fast flashing)
State Signal
Network strength low / Orange (solid)
poor wireless range
Network failure Orange (fast flashing)
* The WIRELESS LED indicator will not go Off within time out or automatic standby mode, during the setup process.
Sound channel is inactive after power up
Not configured yet i.e. during manual configuration
Normal operation
Solid light after scanning and storing; turns Off after 10 s time-out
Also shown when checking for connected speakers: long press on STORE
During manual configuration or if a speaker is not configured
Time
- Product is configured wirelessly
- Product is in standby mode
Off after 10 s time-out After pressing STORE: Speaker connections behave normally
200 ms/200 ms No speakers are connected
100 ms/100 ms In setup (scanning) mode and open for connecting speakers
- Connection quality in network is low
100 ms/100 ms Network error or some malfunctioning e.g. subwoofer not found in a SUB 2.1 setup
Time
- Product is switched Off
- Product is in standby mode
- Product behaves normally
Off after 10 s time-out * Lit when power is applied to the BeoLab Transmitter 1, to indicate that it is switched On and becomes
ready for operation
Also lit when reset either by the user (external) or by the BeoLab Transmitter 1 (internal)
Off after 10 s time-out * Lit when switching Off either via Power Link from the source product or when the signal is no longer
present (i.e. silence in 15 minutes)
Off after 10 s time-out * The BeoLab Transmitter 1 is switched On and has sensed an input
200 ms/100 ms Indicate that the power must not be disconnected during the update process
Off when done
100 ms/100 ms Hardware error - product will not revert to normal operation or if revert automatically to normal
operation : see ERROR LOG in ServiceTool
Time
- System connection quality is low. Distance to speaker(s) too long
100 ms/100 ms Network error or other malfunctioning
LED indications
Comment
Comment
Comment
Comment
18