Push Button Functions - Bang & Olufsen Beolab transmitter 1 Installation Manual

Push button functions

State SELECT
Scan X (short)
Store default -
Show Power Link channel -
Manual configuration mode X (long)
Shift noise to next speaker X (short)
Finish manual configuration * X (long)
Store -
Store * -
Below: Press buttons simultaneously!
Cancel X (short)
Reset association X (long)
Factory reset X (very long) X (very long)
* Functions available with the SW ver. 1.1 and newer.
Note: The cancel function me be used whenever a configuration of a speaker with at sound channel is to be regretted
If the product is a BeoVision 11/BeoPlay V1 or BeoSystem 4, it is possible to press the STORE button when the scan is completed. All configuration
of the speakers can then be handled via the SPEAKER CONNECTIONS menu.
STORE Time
- ≤1.5 s In non-configuration mode: Scans for wireless speakers
In configuration mode: Lit Power Link LEDs to show the number of speakers found
X (short) ≤1.5 s Scanning completed: store default. Note: when SUB 2.1 is set to On, manual configuration is forced
X (long) ≥ 1.5 s and ≤10 s Show status on Power Link LEDs (turns Off after 10 s time-out)
- ≥ 1.5 s and ≤10 s Configuration mode: Mode for manually configuring the match between the sound channel and a
speaker
- ≤1.5 s Configuration mode: Move emitted noise to another speaker
≥ 1.5 s and ≤10 s Configuration mode: Finish manual configuration whenever desired
X (short) ≤1.5 s Configuration mode: Stores the configuration of the match between the sound channel and a
speaker and continue with next channel
X (long) ≥ 1.5 s and ≤10 s Configuration mode: Stores the configuration of the match between the sound channel and a
speaker and remain on same channel to be matched with another speaker
X (short) ≤1.5 s Configuration mode: Move emitted noise one step back to previous sound channel to reconfigure an
inadvertently stored configuration
X (long) ≥ 1.5 s and ≤10 s Erase speaker mapping.
Bang & Olufsen speakers will then flash green. If not press (long) the RESET button on the speaker(s)
≥ 10 s Erase speaker mapping, and resets the settings to factory default
Bang & Olufsen speakers will then flash green. If not press (long) the RESET button on the speaker(s)
Push button functions
Comment
17