Makita HR5201C Instruction Manual page 10

007851
Run the tool for several minutes to warm it up. Switch off
and unplug the tool.
Loosen the six screws and remove the handle. Note that
the top screws are different from other screws.
Disconnect the connector by pulling them.
3
007852
Loosen the screws and remove the change lever.
2
007901
Remove the crank cap cover.
Remove the control plate. (Except for model HR5211C.)
007853
Loosen the six screws with a screwdriver and remove
the crank cap. Rest the tool on the table with the bit end
pointing upwards. This will allow the old grease to collect
inside the crank housing.
1. Screws
1
1. Black
2. White
3. Connector
1
2
1. Change lever
3
2. Screw
3. Crank cap cover
1
1. Control plate
1
007854
Wipe out the old grease inside and replace with a fresh
grease (60 g). Use only Makita genuine hammer grease
(optional accessory). Filling with more than the specified
amount of grease (approx. 60 g) can cause faulty
hammering action or tool failure. Fill only with the
specified amount of grease.
007855
Reinstall the crank cap and tighten with the screwdriver.
Connect the connector and reinstall the handle.
1
007856
CAUTION:
Do not tighten the crank cap excessively. It is made
•
of resin and is subject to breakage.
Be careful not to damage the connector or lead
•
wires especially when wiping out the old grease or
installing the handle.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
10
1. Screwdriver
2. Crank cap
1
2
1. Hammer grease
1
1. Connector
2. Black
3. White
2
3