Vermont Castings Encore 2040 Homeowner's Installation And Operating Manual page 14

Encore 2040 Non-Catalytic / Catalytic Woodburning Stove
®
Distance from the center of the Flue collar to the wall in Top-exit installations
The information on this page is helpful in planning stove placement for top-exiting installations, particularly those in-
stallations with chimneys that pass through the ceiling. However, this is not a clearance chart. Final stove clearances
must adhere to the guidelines stated in the clearance chart on Page 13.
Dimensions indicated are valid for installations with either 6" or 8" flue collars.
Unprotected Surfaces
parallel installations
Side (A)
32Z\x"
(826 mm)
A
*
* This distance, from the center of the flue collar to the front edge of the hearth, is the same for all installations on this page:
35 " in the United States and 37
Z\₄
Unprotected Surfaces
parallel installations
Side (A)
32Z\x"
(826 mm)
A
**To locate center of flue collar for corner installation, add 6
Mark off the resulting distance from the corner along both walls. Next, measure the same distance from these two points out
from the walls. These last two measurements will meet at a point representing the center of the flue collar. Refer to the dia-
grams above.
14
encore: wiThoUT chimney connector heat Shields
corner
installations**
Rear (B) Side (A)
23Z\₄" 22Z\x"
(591 mm) (572 mm)
B
C
" (946 mm) in Canada.
Z\₄
encore: wiTh chimney connector heat Shields
corner
installations**
Rear (B) Corner (C)
13Z\₄" 22Z\x"
(337 mm) (572 mm)
B
C
ST632a
Encore
flue centerline
Diagrams
02/01
parallel installations
Side (D)
18Z\x"
(470 mm)
D
*
ST632
Encore
flue centerline
Diagrams
2/01
parallel installations
Side (D)
19Z\x"
(495 mm)
D
" (165 mm) to the clearance distance from stove corner to wall.
Z\x
protected Surfaces
Rear (E)
10Z\₄"
(260 mm)
E
protected Surfaces
Rear (E)
9Z\₄"
(235 mm)
E
corner
installations**
Corner (F)
18Z\x"
(470 mm)
F
ST632
corner
installations**
Corner (F)
18Z\x"
(470 mm)
F
ST632a
30005295