Checking Gas Level; Check Air Cleaner Element - LIFAN Power USA ESI-1000i Operating Instructions And Owner's Manual

3. Check the Gas Level
Gasoline is extremely flammable and is explosive under certain Conditions.
Do not smoke or allow flames or sparks where the generator is refueled or where gasoline is stored. Refuel in a
well-ventilated area with the engine stopped.
DO NOT overfill fuel tank. Tighten fuel cap after adding fuel.
Be careful and avoid gas spillage when adding fuel, spilled fuel or gas fumes can catch on fire. In the case of any fuel
spillage, be sure that all fuel has vaporized or has been cleaned up before starting engine.
Avoid contact with fuel or breathing gas fumes.
Check the gasoline level ; prior to starting the generator., Fill the gasoline tank to proper levels
gasoline .Always fill with fresh and clean gasoline. Avoid allowing dirt or water into the fuel tank. Tighten the fuel tank cap after
adding fuel.
Diagram #10002
4. Check the Air Cleaner Element
Keep the element clean and free of contaminants at all times.
1. Remove the screws on the left access cover, open it.
2. Remove the three screws on the air cleaner case.
3. Pull out the air cleaner cartridge following the direction of the arrow point.
4. Check the air cleaner element, clean or change with a new one if necessary.
5. Re-install the air cleaner, air cleaner cover, and access cover.
Always wash hands or areas exposed to fuel.
( 2/3 full) with 87 octane
Diagram#10003
9