Visual Trailing - Lowrance GlobalMap 5200C GPS Operation Instructions Manual

The other two methods provide a full range of navigation data and
work with both the Map Page and Navigation Page. The only difference
between them is "navigating a trail" follows a trail forward (from start
to end) while "backtracking" follows a trail in reverse (from end to
start.)
When hiking at walking speed with a hand-held GPS, we often just use
visual back trailing because it is a bit better at following each little
turn on a foot path. At faster speeds, such as the highway or on the wa-
ter, the Navigate Trail and Backtrack Trail commands are handy.

Visual Trailing

1. On the Map Page, zoom (
2. Begin moving and watch the Map Page. Walk or steer so that your
current position arrow traces along the trail you have just made.
Tip:
Generally, when using this method, the smaller the zoom range,
the more accurately you will be able to steer along the trail.
Navigate a Trail (forward)
The following figures illustrate the menu sequence for navigating a
trail.
1. Press |
MENU
2. Press ↓|↓ to enter the Saved Trail list, then use ↑ or ↓ to select the
desired Trail|
ENT
3. Press → to
D
4. Press ↓ to
N
mation along the trail.
NOTE:
If you are already located at or near the beginning of your trail, the
arrival alarm will go off as soon as you hit Enter. Just press
clear the alarm and proceed.
5. Now, begin moving and follow the trail.
6. When you reach your destination, be sure to cancel your navigation:
press |
MENU MENU
sure; press ←|
www.Busse-Yachtshop.de
ZIN
|↓ to
MENU M
Y
.
|↓ to
T
ELETE RAIL
| . The unit begins showing navigation infor-
ENT
AVIGATE
|↓ to
C
ANCEL
.
ENT
or ) so the flashing trail is visible.
ZOUT
| .
T ENT
RAILS
| ..
N ENT
AVIGATE
|
N ENT
AVIGATION
52
email: info@busse-yachtshop.de
. The unit asks if you're
to
EXIT