Engine Trim Calibration - Lowrance GlobalMap 5200C GPS Operation Instructions Manual

9. Fill up your tank again, noting how much fuel you added to the tank.
Compare that number to the Fuel Used figure displayed on the page
you customized. If the amount of fuel you added to the tank and the
fuel used figure are off by more than 3 percent, we recommend the en-
gine interface be calibrated.
NOTE:
You must use the gauge's Fill Tank command when filling your fuel
tank to keep the engine interface updated with correct information
on the amount of fuel in the tank.
To calibrate a Suzuki Engine Interface:
10. If calibration is necessary, press
press .
ENT
11. Highlight
F
12. Select
T
ANK
connected to the selected engine interface. Press
13. Highlight
F
pear: Are you sure you wish to Fill Tank? Select
14. The following message will appear: Do you wish to re-calibrate the
device? Select
Y
15. Repeat these steps for each engine interface you want to calibrate.

Engine Trim Calibration

Engine Trim is calibrated through the Suzuki Engine Interface Device
Configuration menu.
1. Press |
MENU
2. Choose
B S
US
face connected to the desired engine and press
3. Highlight
C
ALIBRATE
dow will appear with a list of Calibration Instructions.
4. Highlight
S
will appear: Please fully raise the Engine Trim.
5. After engine trim has been fully raised, press
message will appear: Please fully lower the Engine trim.
6. After engine trim has been fully lowered, press
Completed message will appear. Press
7. Repeat these instructions to adjust the engine trim for each engine
connected to a Suzuki Engine Interface. Press
to the main display.
www.Busse-Yachtshop.de
M
UEL ANAGEMENT
and press
L
OCATION
and press
T
ILL ANK
and press
ENT
ES
, select
MENU NMEA 2000
and press
ETUP
and press
T
RIM
C
TART ALIBRATION
|
MENU MENU
and press .
ENT
to choose the location of the tank
ENT
. The following message will ap-
ENT
.
and press
. Select the Suzuki Engine Inter-
ENTER
. The Device Calibration win-
ENT
and press
ENT
.
ENT
141
email: info@busse-yachtshop.de
, select
NMEA 2000
.
ENT
and press
Y
ES
.
ENT
.
ENT
. The following message
. The following
ENT
. A Calibration
ENT
repeatedly to return
EXIT
and
.
ENT