Range Hood - Broan ALLURE QS3 SERIES Instructions Manual

at
:: com
.
rangehoods
PREPARE THE HOOD
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Vertical
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Horizontal Discharge)
10 Remove appropriate Duct Knockout(s) from top or back of
hood.
TIES
SCREW
METAL STRIP
PLATE
11 Horizontal Discharge Only: Remove the Plate in front of the
horizontal discharge knockout. Cut the Ties, lift plate out,
and discard plate. DO NOT REMOVE the Metal Strip held
in place with two Screws.
Call 1-800-667-8721 anywhere in the US and Canada
®
:: com
.
rangehoods
Broan at
PREPARE THE HOOD
UP TO 1"
SIDE-TO-SIDE
ADJUSTMENT
PIVOT
12 3¼" x 10" Ducted Discharge Only: Remove Tape from
damper flap and attach Damper/Duct Connector over
knockout opening with screws removed in Step 4 under
"PREPARE THE HOOD". Make sure damper Pivot is nearest
to Top/Back Edge of hood.
NOTE Damper/Duct Connector can be installed up to 1-inch
on either side of hood center - to accomodate off-center
ductwork. In extreme off-center installations, one end
of the duct connector may need to be trimmed to clear
the electrical cable clamp.
accessories
::
kitchen
is a division of
U N L I M
- www.rangehoods.com
ALLURE ® QS3 SERIES

RANGE HOOD

Page 4
TAPE TOP/BACK
DAMPER/
DUCT
CONNECTOR
(Vertical
discharge
position shown)
I T E D
EDGE