Range Hood - Broan Allure QS1 Series Instructions Manual

PREPARE THE HOOD
WIRING
COVER
3 Remove Wiring Cover from inside the hood. Set cover and
mounting screw aside.
4 Remove either top or back wiring knockout and install
approved Electrical Cable Clamp.
Ducted Installation — Skip to Step 10.
The following Steps (5 thru 9) are for
NON-DUCTED INSTALLATION ONLY.
(3) NO. 8 SCREWS
(2) NO. 8 SCREWS
5 Remove Light Panel — held in place with (3) no. 8 screws
and (2) no. 8 screws. Disconnect light assembly wire
harness (white connector).
PREPARE THE HOOD
6
7
ELECTRICAL
CABLE CLAMP
8
LIGHT
PANEL
9
AIR CHUTE
Remove Air Chute
- held in place with
one (1) screw.
NOTE: Be careful
not to
disconnect
any wires.
SLOTS
Remove Baffl e
from air chute.
Tabs will
disengage
from Slots.
Rotate baffl e. Reinsert
baffl e into air chute (as
shown) so that baffl e
fi ts all the way into air
chute. An audible
"click" will be heard
when fully installed.
This will direct air
fl ow through the
non-ducted slots
on top of hood.
Re-install air chute and screw, re-connect wire harness,
and replace light panel.
NOTE: Be careful not to trap wires between Support Fin
and light panel.
®
ALLURE QS1 SERIES

RANGE HOOD

Page 3
TABS BAFFLE
SUPPORT FIN