Operation Mode; Network Settings - iBall iB-WRX150NE Baton User Manual


Note:
a. If you generate a new PIN code for your Router, please enter the new one instead.
b. The WPS LED on the Router will light green for two minutes if the device has been
successfully added to the network.
c. The WPS function cannot be configured if the Wireless Function of the Router is disabled.
Please make sure the Wireless Function is enabled before configuring the WPS.

4.5 Operation Mode

Wireless Router - In this mode, the device enables multiusers to share Internet via ADSL/Cable
Modem. The wireless port share the same IP to ISP through Ethernet WAN port. The Wireless
port acts the same as a LAN port while at Wireless Router mode.
Wireless Client Router - In this mode, the device enables multiusers to share Internet from WISP.
The LAN port devices share the same IP from WISP through Wireless port. While connecting to
WISP, the Wireless port works as a WAN port at Wireless Client Router mode. The Ethernet port
acts as a LAN port.

4.6 Network Settings

Figure 4-20 the Network Settings menu
There are three submenus under the Network menu (shown in Figure 4-20): LAN, WAN and MAC
Cloning. Click any of them, and you will be able to configure the corresponding function.
iB-WRX150NE
Figure 4-18
Figure 4-19 Wireless Operation Mode Settings
150M Extreme Wireless-N Router
- 24 -