Installation And Maintenance; Getting Started - Timex T152 Manual

Rotating alarm clock with nature sounds

Hide thumbs

Table Of Contents

Table of Contents

1. Place unit on a level surface away from sources of direct sunlight or excessive heat.

Note: Protect your furniture when placing your unit on a natural oil or lacquered finish.

A cloth or other protective material should be placed between it and the

furniture.

2. Open battery compartment and install batteries as Getting Started.

3. Clean your unit with a soft cloth moistened only with mild soap and water. Stronger

cleaning agents, such as Benzine, thinner or similar materials can mar the surface

of the case.

4. If the unit is not to be used for a prolonged period, such as a month or longer, remove

the batteries to prevent possible corrosion. Should the battery compartment become

corroded or dirty, clean the compartment thoroughly and replace all the batteries.

Important!

You may need to remove the Try-Me Pull Tab from the back of this unit.

The Pull Tab is for in-store use only. Throw the plastic tab away.

The Rotating Temperature Alarm Clock operates either by AC adapter or batteries. It

including 3 "AAA" batteries is meant for in-store demonstration use only, and should be

replaced with fresh batteries when the Alarm Clock is brought home. Also, it needs a

CR-2032 (not including) lithium battery for alarm clock setting backup. To replace or

install the batteries, follow these instructions:

Install Backup Batteries:

1. The battery compartment is located on the

back of the cabinet and opens the battery

compartment door.

2. Take out all "AAA" batteries if necessary and

then insert a flat-headed screwdriver into the

slot on the back up battery compartment cover,

gently pry off and remove the back up battery

cover.

3. Install a "CR-2032" lithium battery into the back

up battery compartment, making sure that the

positive and negative polarities match up as

indicated inside the battery box.

4. Close the back up battery compartment cover,

making sure the cover latch clicks shut.