Selecting A Location - Winix AW600 Manual

INSTALLATION

Selecting a Location

Do not install the unit under direct sunlight.
Long Exposure to direct sunlight can cause defects.
HumidiPür ‚ must be installed and operated on an even surface.
TM
Vibrations and noise can occur on soft or non-flat surfaces.
Product must be installed approximately 10cm/ 4 inches away from
the wall and 30-40cm/ 15 inches from other electronic appliances.
Before operating the HumidiPür TM , remove any plastic bags and
polyfoams from outside and inside the unit.
OPERATION
Set-Up Instructions
Slide water tank out, by using the
release lever located below the water
tank on the front of the unit.
Fill the water tank with cool tap water
up to the indicator line on the inside
of water tank.
Replace the water tank by sliding it
back into the unit until you hear it click
into place.
Gently slide down the front panel and
make sure that it is seated properly and
lines up correctly.
Make sure to unplug the power cord before filling the unit with water.
Warning
We recommend to use filtered water to prolong the life of the product.
Use cautions when moving the unit filled with water.
Saw Tooth Gear Disc