Troubleshooting - Winix AW600 Manual

TROUBLESHOOTING

Symptom Check If:
HumidiPür TM does
Power cord is plugged in.
not turn on
Low Water Indicator light
is on.
Water is filled inside water
tank.
Auto Mode is not
Power cord is plugged in.
working
Auto Mode Indicator is on.
Vibrates or makes
The unit is located on an
uneven surface.
noise
Power cord is hot
Power cord is plugged in.
Solution
Plug the power cord in.
Fill the water tank.
Make sure the water tank is
in place and filled correctly.
Unplug power cord and
plug it back in.
Push FUNCTION button to
select Auto Mode.
Move to an even surface.
Unplug the power cord and
contact customer support.
Symptom Check If:
Humidity level reading is
When evaluating the
performance of the Humidipür,
not changing or does
keep in mind that there are
not reach desired level.
various factors that influence
humidity level such as:
•Home insulation
•Layout
•Air circulation
•Water level of the CleanCel
water tank
•Ceiling height and square
footage
Function button is
Child-Lock mode is on.
not working
Unpleasant odors are
HumidiPür TM is being used
present where strong odors and/or
dust is present
Low water level indicator
Water is left inside the
water tank.
is on despite water being
in tank
Solution
If the unit is utilizing the water
inside the CleanCel water tank
more than once daily, then the
unit is operating properly. Refill
water regularly for optimal
performance.
Note : In the case of extremely
dry environments, continuous
operation of the Humidipür unit
(up to 1 week) is recommended.
Push Plasma/Child Lock
button for 3 seconds to
turn OFF Child-Lock mode.
Replace the water in the
water tank and change water
more frequently.
Clean water tank and
CleanCel Antibacterial
Discs.
Refill the water tank.