Miele FN 9752 i Operating And Installation Instructions page 42

Building in the appliance
^ Fit the cover g onto the fixing
bracket h.
^ Secure the fixing bracket h to the
bottom of the appliance with the
screws i (M5 x 15).
^ Carefully remove the protective foil
from the sealing strip j.
^ Apply the sealing strip to the side of
the appliance on which the door is
opened so that it is flush with the
front edge of the appliance. The
sealing strip should meet up with the
lower edge of the cover d. Cut the
sealing strip 2 - 3 mm above the
bottom fixing bracket h, if
necessary.
^ Push the appliance into its niche until
the covers d and g touch the front
edge of the side walls of the housing
unit.
42
Building in the appliance
– With 16 mm thick furniture walls:
The spacers should touch the front
edge at the top and bottom of the
side walls of the housing unit, detail
a.
– With 19 mm thick furniture walls:
The front edges of the top and
bottom hinges sit flush with the front
edge of the housing unit side walls,
detail b.
^ Make sure that the plastic covers on
the top and bottom fixing brackets sit
flush with the front edges of the
housing unit side walls, detail d.
This will create a gap of 42 mm to the
front edges of the housing unit side
walls.