Internet Fax Return Receipt Error Messages - Panasonic DP-8020P Operating Instructions Manual

Internet Fax Return Receipt Error Messages

Error messages that are printed on the Internet Fax Return Receipt when remote programming of the Auto Dialler via
email fails.
Error Message
1 Format Error : <@command block, the
"@end" command is missing.>
2 Format Error : <@begin block, the
"@begin" command is missing.>
3 Format Error : <@begin block, the "@end"
command is missing.>
4 Format Error : <@system block, the
"@end" command is missing.>
5 Format Error : <@sender block, the
"@end" command is missing.>
6 Format Error : <@domain block, the
"@end" command is missing.>
7 Format Error : <@program block, the
"@end" command is missing.>
8 Format Error : <@system block, the
"@system" command is missing.>
9 Permission denied : <Fax Forward
parameter is set to "Valid".>
10 Permission denied : <Fax machine is busy
performing a task.>
11 Error : <Programmed ABBR overwrite
prohibited. Use open ABBR only.>
12 Permission denied : <Password is
incorrect.>
13 Permission denied : <Remote Dialler
Update parameter is set to "Invalid".>
14 Format Error : <error line>
15 Warning : <error line>
16 Warning : Field limit exceeded<error line>
Possible Cause / Action
The block termination command "@end" is missing in the
"@command" block, add the "@end" command and try again.
The block start command "@begin" is missing in the "@begin" block,
add the "@begin" command and try again.
The block termination command "@end" is missing in the "@begin"
block, add the "@end" command and try again.
The block termination command "@end" is missing in the "@system"
block, add the "@end" command and try again.
The block termination command "@end" is missing in the "@sender"
block, add the "@end" command and try again.
The block termination command "@end" is missing in the "@domain"
block, add the "@end" command and try again.
The block termination command "@end" is missing in the
"@program" block, add the "@end" command and try again.
The system block start command "@system" is missing in the
"@system" block, add the "@system" command and try again.
Change the Fax Forward parameter to "Invalid" and try again.
Try again later when the machine is not busy.
Cannot overwrite existing programmed data, use the "Delete"
command to erase the existing data first.
Correct the password and try again.
Set the Remote Dialler Update parameter to "Valid".
The format of the Entry is incorrect / incomplete or the data string for
each station is not defined within a single line.
The format of the Entry is incorrect or the number of characters
entered, exceed the maximum allowed in the field. Correct it and try
again.
The maximum number of Station Name, Domain Name, Sender
Name, Program Name, etc were exceeded.
173