JJC RM-E4 Quick Start Manual

Infrared remote control instruction

Thank you for purchasing JJC RM-E4 Infrared Remote Control.

For the best performance, please read this instruction carefully before use.

To use RM-E4 Remote Control

For the first time use, please pull out the plastic separator (if your remote control has it) at the

battery holder.

Mount the camera on a tripod (recommended) or place the camera on a stable, level surface.

Press the button and rotate main command dial until (delayed remote) or (quick response

remote) is displayed in the control panel.

Aim the transmitter on the remote control at the infrared receiver on the camera (usually within

+/- 20 degree of the lens axis, from the left to the right and from the top to the bottom) and

press the shutter-release button on the remote control (when using the remote outdoors, make

sure that the subject is not backlit and that the line of site between the transmitter and the

infrared receiver is not blocked by the lens or other obstacles).

How the camera focuses and shoots depends on the option selected for your camera's custom

setting. For further information, check your camera's manual.

Infrared cannot be seen by human eyes. So you will see no visible light from the LED on the

front end of the remote control when operating.

JJC RM-E4

Infrared Remote Control Instruction

Table of Contents

Do you have a question about the RM-E4 and is the answer not in the manual?

Page 1 JJC RM-E4 Infrared Remote Control Instruction Thank you for purchasing JJC RM-E4 Infrared Remote Control. For the best performance, please read this instruction carefully before use. To use RM-E4 Remote Control For the first time use, please pull out the plastic separator (if your remote control has it) at the battery holder.
Page 2 Identifying the buttons T/W button is for change Pentax camera’s lens ZOOM. Part S button is for shutter. (T/W function is not working on Pentax DSLR/SLR camere.) S button for Nikon camera Shutter Part S button for Canon DSLR/SLR camera instant shutter. Part 2S button for 2seconds delay shutter.
Page 3 To Replace the Battery 1. The remote control is powered by a three-volt CR2032 lithium battery which is already included in. 2. After sliding the latch in the direction shown to unlatch the battery holder, remove the holder. 3. Remove the battery from the battery holder. 4.
Page 4 *Only work with shutter function. Nikon part compatible with Nikon Cameras （（（（ N part）））） Digital SLR D70s D40x Film SLR Coolpix 8800 8400 150ED 140ED 130ED 110S LiteTouch 100W Nuvis Nuvis S Copyright of JJC Technology Company...