Related Manuals for Panasonic K-EW114L03E
Summary of Contents for Panasonic K-EW114L03E
- Page 1 HD IR Waterproof Fixed Network Camera Quick Start Guide K-EW114L03E Model No. K-EW114L06E K-EW114L08E Version 1.0.0...
- Page 2 Welcome Thank you for purchasing our network camera! This quick start guide is designed to be a reference tool for your system. Please keep this start guide well for future reference. Please open the accessory bag to check the items one by one in accordance with the list below. Contact your local retailer ASAP if something is missing or damaged in the bag.
- Page 3 6. Daily Maintenance Please shut down the device and then unplug the power cable before you begin daily maintenance work. Do not touch the CCD (CMOS) optic component. You can use the blower to clean the dust on the lens surface.
- Page 4 Table of Contents ............................1 ................1 .................... 2 ........................... 3 ....................... 5 ..........................5 ..........................5 ..........................7 ......................7 ....................7...
- Page 5 You can refer to the following figure for multiple-function combination cable information. See Figure 1-1 Figure 1-1 Multiple-function combination cable Please refer to the following sheet for detailed information. Port Name Function Connection Note Network port Ethernet Connect to standard Ethernet cable. Power input DC12V...
- Page 6 Please refer to the following two figures for dimension information. The unit is mm. See Figure 1-2 and Figure 1-3. Figure 1-2 Dimension illustration 1 Figure 1-3 Dimension illustration 2...
- Page 7 Important • Make sure that the installation area is strong enough to hold the product, such as a concrete ceiling. • Install the camera in the foundation area of the architecture or where sufficient strength is assured. • If a wall or ceiling board such as plasterboard is too weak to support the total weight, the area shall be sufficiently reinforced.
- Page 8 Figure 2-2 Device installation 2...
- Page 9 Quick configuration tool can search current IP address, modify IP address. At the same time, you can use it to upgrade the device. Please note the tool only applies to the IP addresses in the same segment. Double click the “ConfigTools.exe” icon, you can see an interface is shown as in Figure 3-1. In the device list interface, you can view device IP address, port number, subnet mask, default gateway, MAC address and etc.
- Page 10 If you want to modify the device IP address without logging in the device web interface, you can go to the configuration tool main interface to set. In the configuration tool search interface (Figure 3-1), please select a device IP address and then double click it to open the login interface.
-
Page 11: Web Operation
4 Web Operation This series network camera products support the Web access and management via PC. Web includes several modules: Monitor channel preview, system configuration, alarm and etc. Please follow the steps listed below for network connection. Make sure the network camera has connected to the network properly. Please set the IP address, subnet mask and gateway of the PC and the network camera respectively. - Page 12 Figure 4- 2 If it is your first time to log in, system pops up warning information to ask you whether install web plug-in or not after you logged in for one minute. For detailed plug-in installation, please refer to the Web Operation Manual included in the resource CD.