10. Align the drive bay assembly with the two slots and rails on the sides of the
11. Reinstall the front bezel.
12. Go to "Completing the FRU replacement" on page 124.
116
Hardware Maintenance Manual
6. Slide the optical drive being replaced out the front of the drive bay assembly.
7. Remove the retainer bracket from the failing drive and install it on the new
drive.
8. Install the new optical drive into the bay until it snaps into position.
9. Reconnect the signal and power cables to the rear of the optical drive.
chassis and slide the drive bay assembly towards the rear of the chassis until
it snaps into position.