Lenovo ThinkCentre 8700 Hardware Maintenance Manual page 110

18. Lower the microprocessor straight down into the socket.
19. To secure the microprocessor in the socket, close the microprocessor retainer
20. Install the heat sink and fan assembly on the new system board.
21. Reconnect the heat sink and fan assembly cable to the system board. See the
22. Install the new system board into the chassis and align the screw holes with
23. Reconnect all disconnected cables to the system board.
24. Reinstall the hard disk drive. See "Replacing the hard disk drive" on page 112.
25. Align the drive bay assembly with the two slots and rails on the sides of the
26. Reinstall the front bezel.
27. Reinstall any PCI adapter cards that were removed.
28. Position the fan duct on the heat sink fan.
29. Go to "Completing the FRU replacement" on page 124.
104
Hardware Maintenance Manual
and lock it into position with the small handle.
system board illustration for your machine type at "Identifying parts on the
system board" on page 89.
those in the chassis. Insert and tighten the screws the were removed
previously.
chassis, reconnect the drive cables on the system board, and then slide the
drive bay assembly towards the rear of the chassis until it snaps into position.