Advertisement
5. Connect interface harness to proper wires using the wire chart provided on pages 3
& 5. Note: not all connections are necessary for every install, some wires may be
optional.
6. Note: the aftermarket radio's constant power, ground, and power antenna need to
be connected to vehicles radio harness, the interface does not provide these
connections.
7. SOLDER ALL CONNECTIONS!
Factory Connector
*Steering Wheel Controls:
-
Some radios are controlled by a single wire
(Kenwood)
-
Some radios are controlled via 3.5mm plug. For
these radios, connect the supplied 3.5mm jack
wire (center lead) to the White (IR OUT) wire and
plug male end into radio IR port.
:
Agreement
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
Note 2: Reverse not supported on HUR-997 (sports car) KIT210.
Supplied
Coupler
Basic MOST-HUR connection diagram
Fiber Extension Cable
4 |
JR, BM
4/11/14
NTV-DOC137
rB4
P a g e
Advertisement
