Parts Of The Heater - Hunter HPH15-E Owner's Manual

PARTS OF THE HEATER

Parts of the Heater
1. Control Panel
2. Safety Grille
3. Stand
4. Handheld Remote
Control
5. LED Display
6. Power Light
(Figure 1)
OPERATING INSTRUCTIONS
Operation
1. Place the heater on a firm, level surface, after assembling per
this manual. This heater can be oriented vertically as per Figure
3 or horizontally as per Figure 4. Plastic or rubber tabs, like the
feet on this unit, may stick to furniture surfaces and/or hardwood
floors. The unit may leave a residue that could darken, stain or
leave permanent blemishes on the finish of certain furniture
surfaces, including wood surfaces, and/or hardwood floors.
2. Plug the cord set into a 120 volt AC outlet. Be sure that the
plug fits tightly into outlet. When plugs fit loosely into
receptacles, they may slip partially or completely out of the
receptacle with only the slight movement of the attached cord.
Receptacles in this condition may overheat and pose a serious
fire hazard; if covered by a curtain or drape, the fire hazard is
even greater.
3. When the heater is initially plugged in, there will be a "beep"
and the Power Light will come on indicating that there is power
to the unit. The Power Light will remain lit until the heater is
unplugged from the electrical outlet. (Figure 2)
4. Turn the heater ON by pressing the Power Button
5. The heater will start at the Low heat setting, the LED light
above the button will light up. At this setting, the heater
output is 900 W.
6. Press the button
room is comfortable, select
and to prevent the room from becoming too warm.
Symbols
Power Button
Low Heat Setting Button
High Heat Setting Button
Timer Button
Oscillation Button
(Figure 2)
for fast warm up of a room. Once the
to reduce electrical consumption
.
5
4
6
5
1
2
Figure 1
Figure 2
Figure 3
Figure 4
81604-01 R20140808
3