Bosch ISW-EN1215EOL User Manual

Universal Transmitter
ISW-EN1215EOL with Wall Tamper
Overview
The ISW-EN1215EOL universal transmitter with an included
wall tamper switch can be used with any standard contact or
sensor. A 2.2 kΩ end of line (EOL) resistor is included with
this transmitter, and is required for operation.
This transmitter includes a back tamper switch. The tamper
condition must be defined within the control panel as a
trouble condition when the system is disarmed, and as an
alarm condition when the system is armed.
Figure 1: Transmitter Components
10
9
1 - Wall-mount screw 6 - Tamper switch with
holes spring
2 - Housing screw hole 7 - Antenna
3 - Frequency Band pins 8 - Housing release tab
4 - RESET button 9 - Battery
5 - N/O–N/C jumper 10 - Input terminal
1.0 Installation and Startup
•
This product is designed to be installed and
maintained by professional security technicians.
•
This transmitter is intended for indoor use.
•
Manually test this product weekly.
1.1 Open the Housing
Use a small flat blade screwdriver to press the housing
1.
release tab on the bottom of the transmitter (refer to
Figure 1).
Separate the housing cover from the housing base. Refer
2.
to Figure 2.
1
Figure 2: Open the Housing
2
3
4
5
6
7
1 - Housing cover
1.2 Mount the Transmitter
Route the external wiring through the wall. Refer to
1.
Figure 3.
1
Mount the transmitter on the wall using the supplied
2.
screws. Refer to Figure 1 for the wall mount screw hole
8
locations.
Ensure that the housing base is flush against the wall and
3.
the wall tamper switch is firmly pressed.
1
2
2 - Housing base
Figure 3: Mount the Transmitter on the Wall
1
2
1 - Wall tamper switch
2 - External wiring
1.3 Configure the Transmitter
1.3.1 Select the Frequency Band
Select the appropriate frequency band for your
1.
geographic area.
Place a selection jumper on the appropriate Frequency
2.
Band pins (refer to Figure 4).
Figure 4: Frequency Band Settings
1
2
3
1 - North America (902 MHz to 928 MHz) (default)
2 - Australia (915 MHz to 928 MHz)
3 - New Zealand (921 MHz to 928 MHz)
AU NZ
AU NZ
AU NZ