Intercom Feature; Contacts (Private/Shared); Configuring Call Settings; Speed Dials - Cisco 232D User Manual

Intercom Feature

The intercom feature allows you
to directly dial another handset
that is registered to the same
Cisco SPA232D. To use the
intercom feature, press the
Options softkey and choose
Intercom. Choose the handset
you want to call from the list and
press the centre Select button.
The handset you have selected
receives the call from your
handset, and can answer the call or ignore the call.

Configuring Call Settings

To reach the Call Settings menu, press the centre Select button, scroll to Call
Settings, and press the centre Select button again.
In the Call Settings menu, press the up and down arrow buttons to select the
settings you want to change and press the Select button. Available
configuration options are described in the following sections.

Speed Dials

You can configure up to 9 speed dials (numbers 2
through 9 and 0) on your handset. A speed dial
number can be configured by pressing and holding
an unassigned number on the keypad, or by using
the Call Settings
on the handset.

Call Forwarding

You can forward all calls to another phone number, forward calls when your phone is busy, or forward calls to another
phone number when there is no answer at your phone.
Flip Solutions Ltd t/a Flip Connect
Phone: 020 3056 5060 | Fax: 0870 421 5411 | E-Mail: sales@flipconnect.co.uk

Contacts (Private/Shared)

You can store private and shared
contacts on your handset. Private
contacts are
handset. Shared
available on all handsets registered
to the Cisco SPA232D. When a
shared contact is entered from a
handset, the contact is made
available to all handsets registered
to the same base station.
You can configure up to 100 private
contacts and 50 shared contacts on the Cisco SPA302D.
Note: LDAP-Corporate directory search is not available on
this particular device.

Call Preferences

Do Not Disturb:
do not reach the handset
(They will not display in the
Received Calls list). If more
menu
than
connected to the base station
and the DND is enabled then
all the
synchronised and will not
accept calls.
Call Waiting:
enabled, while on a call, a
beep tone will alert you of a second incoming call.
Block Caller ID:
from being sent when placing a call.
Block Anonymous Call:
handset from callers who have blocked their Caller ID.
User Guide | Cisco 232D & 302D
specific to each
contacts are
Incoming calls
one handset is
handsets are
If call waiting is
Prevents your Caller ID information
Blocks incoming calls to your
| 02/07/2014
4