Bradford White RTG 199HE Installation Instructions Manual page 4

Installing outdoor kit
4 Installing outdoor kit
4.1 Replace the control panel shield
▶ Loosen the two Philips head screws located on bottom rear
of cover (see Fig. 2).
Fig. 2 Loosen the two screws
▶ Remove the front cover panel and replace the original
control panel shield with shield provided in the kit, see Fig.
3.
Fig. 3 Replace the control panel shield
4
WARNING:
▶ The control panel shield must always
remain closed, except when making
adjustments, to prevent damage to
heater from weather.
▶ After replacing the control panel shield re-position the
front cover.
▶ 1. Remove the cover plate (A) from the top of the
appliance, as shown in Fig. 4.
Fig. 4
▶ 2. Attach the supports (B) to the appliance with the four
provided screws, as shown in Fig. 4.
Before mounting the outdoor kit on the appliance:
Remove the exhaust seal from outdoor vent cap:
For condensing appliances only:
▶ Remove inner seal, see Fig. 5.
Fig. 5 Condensing appliances only (RTG 199HE)
Outdoor kit – 6 720 811 755 (2014/05)
6720645551-16.1V