Electrical Connections - Bradford White RTG 199HE Installation Instructions Manual

Electrical connections

▶ Close the recess box cover with padlock (optional).
Fig. 21
8 Electrical connections
8.1 Electrical power supply
WARNING:
▶ For safety reasons, disconnect the
power supply cord to the heater before
any service or testing is performed.
WARNING:
▶ This heater must be electrically
grounded in accordance with the most
recent edition of the National Electrical
Code. NFPA 70. In Canada, all electrical
wiring to the heater should be in
accordance with local codes and the
Canadian Electrical Code, CSA C22.1
Part 1. Do not rely on the gas or water
piping to ground the metal parts of the
heater
10
The water heater requires an electrical power supply from a
120VAC / 60Hz circuit (with a dedicated outlet) and must be
properly grounded.
The heater is wired as shown in the wiring diagram of the water
heater installation manual.
Fig. 22
[1] Power cord length: 3ft.
Note: Outlet appliance is plugged in to should be clear from
possible water damage.
6720645551-08.1V
▶ Refer to water installation manual to complete installation
▶ Start and operate the water heater according to the water
Connecting power supply cord
WARNING:
▶ Confirm that the water heater is
appropriately grounded and that the
installation meets all applicable
electrical codes for outdoor
installations.
of gas and water piping connections.
heater installation manual. NOTE: Open the control panel
shield to access the controls of the heater.
Outdoor kit – 6 720 811 755 (2014/05)