Operating The Machine; Normal Burnishing - Windsor Chariot 2 CBPS20 Operating Instructions Manual

Operating the Machine

When operating the machine around people, pay close
attention for unexpected movement. Use extra caution
around children.
1. Stand on the operator platform. Throttle pedal must
be in neutral position.
2. Turn machine power on.
3. Select transport speed from Function Mode Switch.
4. Press the Drive Reset/Directional Control Switch,
selecting the desired travel direction.
5. Select B1 or B2 from the Function Mode Switch.
Deck will Lower.
6. The pad motor will only run when the burnishing
head is lowered to within 2 inches of the floor.
7. Occasionally verify "check pad" indicator light is
"green". If not, stop machine, remove pad driver
and check pad. Replace or flip as needed.
NOTE: To prevent possible damage to the floor
surface, always keep the machine moving while the
pad is spinning.
8. When the head is down and the machine is
propelled, the pad motor runs.
9. When the battery light flashes it indicates
discharged batteries, stop operation and charge
batteries.

Normal Burnishing

Plan the burnishing pattern in advance. The longest
track is around the perimeter of the area to be
burnished. For efficient operation, the runs should be
the longest possible without turning, stopping, or
raising or lowering the burnisher head.
In order to achieve the best possible results, the area
which is to be burnished should be swept and auto
scrubbed before burnishing.
86356230 Chariot iGloss
INEFFICIENT BURNISHING PATH
RECOMMENDED BURNISHING PATH
Operation
21