Table of Contents
Advertisement
Fixing Installation Plate
The wall you select should be strong and solid
enough to prevent vibration
1. Mount the installation plate on the wall with
type "A" screws. If mounting the unit on a
concrete wall, use anchor bolts.
• Mount the installation plate horizontally by
aligning the centerline using a level.
2. Measure the wall and mark the centerline. It
is also important to use caution concerning
the location of the installation plate-routing
of the wiring to power outlets is through the
walls typically. Drilling the hole through the
wall for piping connections must be done
safely.
CHASSIS
(Grade)
A
SD
120(4.7)
110(4.3)
3. Install after removing one of the indicated
cutting phase according to the installation
location of the indoor unit's piping.
Drill a Hole in the Wall
• Drill the piping hole with a ø70mm(2.76in)
hole core drill. Drill the piping hole at either
the right or the left with the hole slightly
slanted to the outdoor side.
Distance mm(in)
B
C
D
43(1.7)
43(1.7)
Installation Plate
Chassis
Hook
Type "A" screw
C
Installation plate
A
Left rear piping
Cutting Phase
WALL
Indoor
Installation
D
B
Right rear piping
Outdoor
Installation Manual 13
Advertisement
Table of Contents
