Table of Contents
Advertisement
INSTALLATION
10
INSTALLATION
Select the best Location
- There should not be any heat or steam near
the unit.
- Select a place where there are no obstacles
around of the unit.
- Make sure that condensation drainage can
be conveniently routed away.
- Do not install near a doorway.
- Ensure that the interval between a wall and
the left (or right) of the unit is more than
100mm. The unit should be installed as high
as possible on the wall, allowing a minimum
of 200mm from ceiling.
- Use a metal detector to locate studs to pre-
vent unnecessary damage to the wall.
More than
100
More than 2300
* The feature can be changed according a
type of model.
CAUTION
!
Install the indoor unit on the wall where
the height from the floor is more than
2300mm.
Fixing Installation Plate
The wall you select should be strong and solid
enough to prevent vibration
1
Mount the installation plate on the wall
with type "A" screws. If mounting the unit
on a concrete wall, use anchor bolts.
- Mount the installation plate horizontally
by aligning the centerline using Horizontal
meter .
More than 200
More than
100
(Unit : mm)
Installation Plate
Chassis
Hook
Installation Plate
Chassis
Hook
Both Installation Plates can be used for this
model.
2
Measure the wall and mark the centerline.
It is also important to use caution concern-
ing the location of the installation plate.
Routing of the wiring to power outlets is
through the walls typically. Drilling the hole
through the wall for piping connections
must be done safely.
Place a level on raised tab
Unit Outline
460
Ø65
Installation Plate
Left rear
Measuring Tape
piping
69
105
Measuring Tape
Hanger
460
Unit
Outline
Ø65
Place a level on raised tab
Left Rear
Installation plate
Piping
184
220
Both Installation Plates can be used for this
model.
Type "A" Screws
Type "A"
570
Ø65
Right rear
piping
56
207
567
Ø65
Right Rear
156
Piping
307
(Unit : mm)
Advertisement
Table of Contents
