Remote Control Transmitter; Output Level Control - Yamaha KX-800/U Owner's Manual

I
REMOTE CONTROL TRANSMITTER
I
2
c:::J
I
3
4
5
6
III
lie;
c::J c:::J c::J
8
8
8
0
c:::J
c::J c:::J c::J
CLEAR
ff
f::J
SEARCH
<J
-
<!<J
'i3i:AY
C>t>
c::::J
c::::J
c:::J
REC/PAUSE
STOP REC MUTE
c:::J
c:::J c:::J
.J.
---,
-
YAMAHA
REMOTE CONTROL
TRANSMITTER
RS-K12
\.
@)
PHONES jack
Connect headphones to this jack for monitoring recording or playback.
Q) OUTPUT LEVEL control
Used to adjust the output level at the PHONES jack and LINE OUT/PLAY
jacks at the rear.
REC/PAUSE: Pressing this button engages the Rec Standby mode, and
REC indicator will light. While in this mode, the PEAK level meters will
function, allowing you to monitor the recording signal level of your
program source. (Refer to the "SETTING RECORDING LEVEL"
section of this manual.) To initiate recording from the Rec Standby
mode, press the PLAY button. Pressing the REC/PAUSE button during
actual recording engages the Pause mode. To resume recording,
press the PLAY button.
STOP: Press this button to stop the tape while in any mode.
MUTE/SEARCH:
During Recording: When the MUTE/SEARCH button is pressed at any
time during recording, a 4- second blank interval is automatically
recorded on the tape (Auto Rec Mute mode). Then, the Rec Pause
mode is engaged automatically.
In order to record a blank interval longer than 4 seconds, press the
MUTE/SEARCH button and hold it in for the desired length of time.
After the button is released, the 4-second blank interval will also be
recorded automatically, then the Rec Pause mode is engaged
automatically.
To resume recording, press the PLAY button.
During Playback: By pressing either the ~ / ~ or ~ / ••• button
simultaneously with this button, the tape will move to the beginning of
the next or current selection, from which point play will be resumed.
7