Intro Scan - Yamaha KX-800/U Owner's Manual

• AUTO REC MUTE
Use this function to effectively cut off unwanted material during recording
or to provide blank section between selections.
1. Press the MUTE/SEARCH button at the beginning of the section not to
be recorded. The unit makes a blank section of about 4 seconds, then
enters rec pause mode.
2. To resume recording, press the PLAY button.
Keep the MUTE/SEARCH button pressed to provide a blank section of
more than 4 seconds.
PLAYBACK
1. Make sure that the AUTO MODE selector is set to the OFF position,
then turn on the POWER switch.
2. Open the cassette compartment by pressing the EJECT button and
load a recorded cassette tape.
3. For a tape recorded with a noise reduction system, set the DOLBY NR
buttons or dbx button according to the system used.
4. Press the PLAY button to start playback.
5. Set the volume and tone controls on the amplifier to adjust sound
quality as desired.
6. To stop playback, press the STOP button.
• O-M REPEAT PLAYBACK
With this function, the desired section can be played back repeatedly up
to 8 times.
1. Set AUTO MODE selector to O-M REPEAT position. The O-M REPEAT
indicator lights.
2. Press RESET button at the beginning of the selection you want to play
again, and set the counter to "0.00".
17
3. Press the MEMORY button at the end of the selection you want to play
again.
The MEMORY indicator lights up and the tape immediately begins
rewinding.
4. The tape is rewound until the counter has returned to "0.00"
(beginning of selection). The deck then enters the playback mode.
5. The tape plays back until it reaches the memorized counter number
(end of selection). In this way, the same selection can be played again.
6. To erase the memory, press the MEMORY button once again.
The MEMORY indicator goes out.
• The length of the start and end points of the O-M repeat section should
be more than 4 seconds:
• The O-M repeat can be carried out between minus counter reading to
0.00.
• FULL REPEAT PLAYBACK
Set the AUTO MODE selector to FULL REPEAT and start playback. The
one side of the cassette is repeatedly played back 8 times. During full
repeat playback FULL REPEAT indicator lights.
• INTRO SCAN
During playback or stop mode, press either of the INTRO keys on the
remote control transmitter. The beginning of each selection is played
back for about 14 seconds in the selected direction. Press the PLAY
button while the beginning of the desired selection is being played back
to set the unit to normal play mode.
I