Yamaha KX-800/U Owner's Manual page 5

o
TAPE button
Used to memorize the tape length. Each time this button is pressed,
display shows C60 - C90 - C46 - C46L. Tap the button until the
loaded tape length appears. The displayed tape length is memorized.
(!)
MONITOR button
This button switches the monitor function between the SOURCE and the
TAPE. This unit is equipped with an auto monitor function, but it can be
changed to manual if so desired, for example, monitoring the just-
recorded signal during tape recording.
o
Display
CD
Linear counter/tape length/remaining time/program/direct
search display
Linear counter: Displays the elapsed time of the tape's running.
*
The linear counter is not a actual watch and its accuracy of the
linear counter depends on the kind of the tape used.
Tape length: Displays the tape length (C60, C90, C46 and C46L) by
pressing the TAPE button.
Remaining time: Displays remaining tape time by pressing REMAIN
button.
Program: Displays the program number and selection number to be
memorized.
Direct search: Displays the selection number to be searched.
®
Repeat function indicators
MEMORY: When the count number is memorized by pressing
MEMORY button, MEMORY indicator lights.
O-M REPEAT: This initiates repeat playback 8 times between "0.00"
setting of the counter and the memorized counter number. When
the AUTO MODE selector is set to O-M REPEAT position, the O-M
REPEAT indicator lights.
FULL REPEAT: When the AUTO MODE selector is set to FULL
REPEAT position, the FULL REPEAT indicator lights.
One side of the cassette is repeatedly played back 8 times from
beginning to end.
®
PEAK level meters
Indicate the peak of the signal level during recording and playback
over a range from -20 dB to +16 dB. It will also display the optimum
recording level monitor.
®
Tape type indicators
When a tape is loaded, the deck's circuitry will automatically adjust for
proper bias, level, and equalization for that type of tape, and the type
of tape will be indicated.
• Automatic tape selection does not function for the old type metal
tapes which do not have a detection hole on the cassette shell.
• This deck is not suited for use with Ferrichrome (FeCr) tapes.
®
Noise reduction indicators
The corresponding noise reduction indicator will light up by pressing
the DOLBY NR buttons or dbx button.
4
I