General Setup; Audio Adjustment; Factory Settings - JBL Synthesis SDP-25 Manual

JBL SYNTHESIS SDP-25

GENERAL SETUP

Before making initial setup adjustments you may wish to change some of the system settings
that will make it easier to configure your SDP-25. To do that, press the OSD button to call up the
Main Menu and then press the Down Navigation Button until General Setup is highlighted. Then,
press Enter to move to that menu.
General Setup
Language
Front Brightness
Volume Units
Volume Default
Volume Level
Units of Measure
RS232 Control
CEC Control
Menu Appearance
Transparency
Status Message
Menus
Global Lip Sync
Auto Power Down
FW Version

Factory Settings

Complete information on the function and adjustments for the settings in this menu may be
found in the full Owner's Manual, which may be downloaded from the Support section of the
JBL Synthesis web site a www.jblsynthesis.com. However, at this time there are three important
settings that you may wish to change.
• The Language setting may be changed to French, Spanish, Dutch, German, or Italian.
• You may display the Speaker Distances in centimeters, rather than inches, by changing the
Units of Measure setting.
• Changing the setting for "Menus" will keep the on-screen menus on the display for up to ten
minutes, making it easier to make initial setup adjustments.
English
75%
dB
On
-30dB
Inch
Off
Off
Mid
3 Seconds
1 Minute
0ms
On
VX.xx/X.xx
• The adjustments made in the General Setup menu are applied to all inputs.
• The Factory Settings option is used to return all settings to their original factory defaults.
When these, or any other adjustments are complete press the Back button on the remote to
return to the Main Menu.
INPUT SETUP
If you have made any connections that are different from those shown in the factory menu
default settings chart on Page 7, press the down navigation button so that Input Setup is
highlighted and press Enter.
Source
Rename
Video Input
Audio Source
Secondary
Digital Audio
Analog Audio
Surround Mode
Lip Sync

Audio Adjustment

Trigger B
Back
The settings in the Audio Adjustment sub-menu are best made when all other setup adjustments
are complete and a source is playing. See Page 12 for more information.
When configuring an Input note the following options:
• Connecting and configuring Secondary analog and/or digital inputs with a source allows
them to be used for the Zone 2 system since the output audio format must be the same as
the input. The SDP-25 does not convert one format to another.
• The Lip Sync setting made in the Input Setup menu is applied for that input source only and
is added to the Global Lip Sync entered in the General Setup Menu.
To turn or activate a voltage-controlled device such as a motorized screen or blinds when a
specific input is in use, change the setting for Trigger B to On.
General Setup / Input Setup
Input Setup
Blu-ray
Blu-ray
HDMI 1
HDMI 1
Coax 1
Audio 1
PLII(x) Movie
0ms
Off
9
- -