Specifications - JBL Synthesis SDP-25 Manual

JBL SYNTHESIS SDP-25

SPECIFICATIONS

MAIN ZONE AUDIO
Frequency Response:
Analog Input Impedance:
Input Level:
Output Impedance:
Digital Coax Signal Strength:
Output Level:
Signal-to-Noise Ratio:
THD + Noise:
Bass Management:
High-Pass Filter:
Low-Pass Filter:
Audio Resolution:
Supported Audio Formats:
Crosstalk:
A/D Conversion:
D/A Conversion:
DSP Engine:
Low Frequency Cutoff:
High Frequency Cutoff:
VIDEO INPUT & OUTPUT CONNECTIONS:
HDMI Inputs:
HDMI Outputs:
HDMI Features:
Composite (CVBS) Video Inputs:
Composite (CVBS) Video Outputs:
20 Hz – 20 kHz, ±0.25dB
47K ohms
4 Vrms in DSP modes
4 Vrms in 2Ch Bypass Mode
480 Ohms
0.5V p-p
4 Vrms
90dB in DSP Modes
98dB in 2ch Bypass Mode
<0.007% in DSP Modes
<0.015% Analog in - Bypass & DSP Modes
1 kHz at 1.0VRMS
2nd order (x7)
4th Order, 40 - 200Hz Crossover Freq.
Up to 7.1 Channels at 192kHZ/24-bit
Dolby TrueHD, DTS-HD Master Audio, DVD Audio
<72dB
24-Bits, up to 192 KHz, Delta-Sigma
114dB DR, -100dB THD+N
24-Bits, up to 192 KHz, Delta-Sigma
114dB DR, -100dB THD+N
Dual TI TMS320D
< 10Hz (All speaker channels in Bypass Mode)
>200Hz (All speakers in Bypass mode, -3dB point)
6 HDMI Type A (19 pin) connectors
1x HDMI Type A (19 pin) connection with
Audio Return Channel
1x HDMI Type A (19 pin) connection for Main/2nd Zone
12-bit Deep Color (1080p)
3D Pass-through
xvYCC (x.v. Color)
Video bandwidth up to 300 MHz
4K support to 2160, 50p/60p, 8-bit, 4:2:0
2x @ 1.0V p-p, 75 ohms
1x 1.0Vp-p, 75 ohms
Component Video Inputs:
Cb/Cr, Pb/Pr:
Y:
AUDIO INPUT & OUTPUT CONNECTIONS:
Analog Audio Inputs:
Analog Audio Outputs:
Digital Audio Inputs:
DATA AND CONTROL CONNECTIONS:
Trigger Outputs:
USB:
Data Connection:
IR Inputs:
IR Outputs:
ELECTRICAL & PHYSICAL SPECIFICATIONS:
Mains Voltage:
Power Consumption:
Unit Dimensions [H x W x D]
Shipping Dimensions: [H x W x D]
Unit Weight:
Shipping Weight:
2x
0.75Vp-p, 75 ohms
1V p-p, 75 ohms
5x stereo single-ended/unbalanced L/R pairs
1 set 7.1 single-ended/unbalanced (L/C/R/LS/RS/LBS/
RBS/Sub)
1x 3.5mm stereo (Front Panel)
2x stereo single-ended/unbalanced L/R pairs
1 set 7.2 single-ended/unbalanced (L/C/R/LS/RS/LBS/
RBS/Sub 1/Sub2)
6x via HDMI
5x Coaxial (RCA) 75 ohms (S/P-DIF)
5x Optical Toslink (S/P-DIF)
1x USB 2.0 Type B
2x 12 VDC, 300mA, Trigger B programmable
1x USB Type A for software updates only
RS-232 via DB-9 connector for Control and System
Feedback
Front Panel IR sensor, switch selectable for on/off
1x IR in, 1x Flasher In, 3.5mm jacks
3x, 3.5mm jacks
120 VAC or 230 VAC [factory-set]
Standby: < 0.5 watts
Maximum Power: 20 watts
6" x 19" x 16.3" / 153 x 483 x 414 mm
11.4x 20.6" x 24.2" / 288mm x 522mm x 613mm
19.5 lb/8.86 kg
26.5 lb/12 kg
Specifications
15
- -