Table of Contents
Advertisement
For Parts Call K&T 606-678-9623 or 606-561-4983
SERVICE AND ADJUSTMENTS
KEPS NUT
TERMINAL
ACCESS
DOOR
TERMINAL
GUARD
FIG. 31
TO REPLACE HEADLIGHT BULB
•
Raise hood.
•
Pull bulb holder out of the hole in the backside of the
grill.
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
•
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
•
Check wiring. See electrical wiring diagram in the
Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
HEX BOLT
POSITIVE
(RED)
CABLE
NEGATIVE
(BLACK)
CABLE
26
www.mymowerparts.com
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 32)
•
Raise hood.
•
Unsnap headlight wire connector.
•
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedures.
02141
FIG. 32
HOOD
HEADLIGHT
WIRE
CONNECTOR
Advertisement
Table of Contents
