For Storage Of The Battery; For The Charging Process - a2b Orsted Operating Instructions Manual

• Do not expose the battery to any kind of
moisture (water, rainwater, snow, etc.)
during storage!
• Charge the battery before storage and
check the state of charge every 3 months.
• Store the battery in a cool and dry
place where it is safe from damage and
unauthorised access.
• To obtain an optimum battery life
cycle, the battery should be stored at a
temperature from 18°C to 23°C and a
humidity of 0 to 80 percent. The state of
charge should be 70 percent.
• Check the battery's state of charge every
3 months during storage and charge it to
70 percent if required.
6.2.3 Safety instructions and warnings

for the charging process

• Only charge the battery in a ventilated,
dry and dust-free environment.
• Never charge the battery in the presence
of or close to flammable liquids or gases.
• Do not expose the battery to any kind of
moisture (water, rainwater, snow, etc.)
during charging.
• Do not charge it in areas in which the
battery could come into contact with
moisture.
• The battery should only be charged at
temperatures between 0°C and 40°C. If
you try to carry out a charging process
beyond this temperature range,
• the battery's automatic system will
automatically switch off the charging
process.
• The battery achieves its maximum life
cycle if charged at temperatures between
10°C and 30°C.
• Only use the intended chargers to charge
the battery. Your specialist dealer will give
you the relevant information.
• Using an inappropriate charger may lead
to malfunctions and result in a shorter
life cycle of the battery. There is also a
danger of fire and explosion.
• After the end of the charging process,
the charger must first be disconnected
from the mains socket and then from the
battery.
• Ensure adequate air circulation as soon
as the battery is charged.
• Only charge the battery under supervision.
• Damaged batteries must not be
recharged or used again.
• Damaged battery chargers (damage
to the plug, casing, cable) must not be
used.
User manual