Photon Focus CameraLink MV1-D1312 series User Manual page 12

Hide thumbs Also See for CameraLink MV1-D1312 series:

Table of Contents

2 How to get started (CameraLink

The sensor has no cover glass, therefore dust on the sensor surface may resemble

to clusters or extended regions of dead pixel.

To choose a lens,

www.photonfocus.com.

Connect the camera to the frame grabber with a suitable CameraLink

CameraLink

cables can be purchased from Photonfocus directly (www.photonfocus.com).

Please note that Photonfocus provides appropriate solutions for your advanced vision

applications.

Figure 2.2: Camera with frame grabber, power supply and cable.

Do not connect or disconnect the CameraLink

For more information about CameraLink

Connect a suitable power supply to the provided 7-pole power plug. For the connector

assembly see Fig. A.1. The pinout of the connector is shown in Appendix A.

Check the correct supply voltage and polarity! Do not exceed the maximum

operating voltage of +12V DC (± 10%).

Connect the power supply to the camera (see Fig. 2.2).

The status LED on the rear of the camera will light red for a short moment, and

then ﬂash green. For more information see Section 5.1.4.

)

see the Lens Finder in the 'Support' area at

cable while camera power is on!

see Section 4.8.

cable (see Fig. 2.2).

Table of Contents