Installation - DeLonghi TCH8093ER Owner's Manual

For service questions, contact DeLonghi at 1-800-322-3848.
For sales inquiries, call Sylvane at 1-800-934-9194.
a suitable outlet.
20. Make sure that the plug is fully inserted into
the outlet. Wall outlets may deteriorate with
time, so check the plug periodically for signs of
overheating or deformation. If the outlet has
deteriorated, stop using it and have it repaired.
21. Check that neither the appliance nor the power
cord have been damaged during shipping.
22. Make sure that no styrofoam or other packing
materials remain in the appliance.
23. The first time the appliance is used, run it at
the maximum power for at least two hours.
During this time, ventilate the room thoroughly
to eliminate the "new" smell released by the
appliance. It is completely normal for the
appliance to emit "creaking" sounds the first time
it is run.
24. CAUTION: To prevent electric shock, make sure
the wide prong of the plug is inserted in the wide
slot of the outlet.
25. Do not place the heater near a bed because
objects such as pillows or blankets can fall off
the bed and be ignited by the heater.
26. Extreme caution is necessary whenever the
heater is left operating unattended.
27. Do not open the appliance. No user-serviceable
parts inside.
SAVE tHESE
InStructIonS
tHIS Product IS For HouSEHoLd uSE onLY
dEScrIPtIon
(see fig. 1)
A
ON/OFF button
B +/- adjustment buttons
c
MODE button (selects the operating mode)
d "ECO plus" button
E Timer button
F
Swivel button
G Remote control receiver
H
Indicator light
I Air intake grille
J Filter
description/use
uSE

Installation

- The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
outlet for other appliances.
Electrical connection
- Before plugging the appliance into the outlet, check that
the outlet power corresponds to the value indicated on the
rating plate and that the outlet power is adequate for the
load.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/EEC
ON RADIO INTERFERENCE SUPPRESSION.
Mounting the base
- Fit the two parts of the base together, matching the guide
pins on the front with the recesses on the back and snapping
the two clips into place (fig. A and fig. B).
- Turn the appliance upside down and fix the base to the body
with the 6 screws supplied (fig. C).
tools needed and estimated time
1 Phillips head screwdriver type PH 2 x 100
6 screws (included)
Assembly time: approx. 5 minutes
operation and use
1. Plug into the outlet.
2. The appliance emits a beep. The indicator light (H) comes
on and remains lit while the appliance is powered.
3. Press the ON/OFF button (A) to turn the appliance on.
The appliance comes on with the setting used during the
previous period of operation.
4. Press the MODE button (c) to select one of the following
operating modes:
Fan
Freeze prevention
Heating 1
Heating 2
Heating 3
4.1 Fan
In this mode, only the fan operates and the appliance does not
heat the room.
4.2 Freeze prevention
In this mode, the appliance keeps the room at a temperature of
45°F (7°C) to avoid freezing.
4.3 Heating 1, 2 and Heating 3
In this mode, the desired temperature can be selected by pressing
5
en