Maintenance; Operation - Broan K41 Installation Instructions Manual

Hide thumbs Also See for K41:
Table of Contents

Advertisement

Available languages

Available languages

MAINTENANCE

Grease Filters
The grease filters should be cleaned frequently.
Use a warm detergent solution. Grease filters
are dishwasher safe.
Remove filters by pushing filters towards the
back of hood and rotating filters downward.
Ductfree Filters
The ductfree filters should be changed every 6 months. Rotate the filters to remove
and replace.
Hood Cleaning
Stainless steel is one of the easiest materials to keep clean. Occasional care will
help preserve its fine appearance.
Cleaning tips:
Hot water with soap or detergent is all that is usually needed.
l
Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to
l
avoid water marks.
For discolorations or deposits that persist, use a non-scratching household cleanser
l
or stainless steel polishing powder with a little water and a soft cloth.
For stubborn cases, use a plastic scouring pad or soft bristle brush together with
l
cleaser and water. Rub lightly in direction of polishing lines or "grain" of the stainless
finish. Avoid using too much pressure which may mar the surface.
DO NOT allow deposits to remain for long periods of time.
l
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere
l
to the surface causing rust.
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to
l
remain in contact with stainless steel for extended periods. Many of these
compounds contain chemicals which may be harmful. Rinse with water after
exposure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.

OPERATION

Controls
The hood is operated using the slide controls
under the front edge of the hood.
The light switch turns the halogen lights on
and off.
The blower on / off switch turns the blower on
to the running speed set by the blower speed
control. The blower must be turned on and off
using this switch.
The blower speed control changes the run-
ning speed of the blower. It is infinitely adjustable
from low to high speed.
The pilot lamp lights up whenever the blower
is on.
GREASE FILTERS
LIGHT
SWITCH
- 6 -
BLOWER
ON / OFF
BLOWER
SWITCH
SPEED
CONTROL
PILOT
LAMP

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

K42

Table of Contents