Fixing The Frame - AEG X91384MIO User Manual

18
INSTALLATION INSTRUCTIONS

Fixing The Frame

• Loosen the two screws fastening the lower chimney and remove
this from the lower frame.
• Loosen the two screws fastening the upper chimney and remove
this from the upper frame.
If you wish to adjust the height of the frame, proceed as follows:
• Unfasten the metric screws joining the two columns, located at the
sides of the frame.
• Adjust the frame to the height required, then replace all the screws
removed as above.
• Insert the upper chimney stack from above, and leave it running
free on the frame.
• Lift up the frame, fit the frame slots onto the screws up to the slot
end positions.
• Tighten the two screws and fasten the other two screws provi-ded
with the hood.
Before tightening the screws completely it is possible to adjust the
frame by turning it. Make sure that the screws do not come out of
their seats in the slotted holes.
• The frame mountings must be secure to withstand the weight of the
hood and any stresses caused by the occasional side thrust applied
to the device. On completion, check that the base is stable, even if
the frame is subjected to bending.
• In all cases where the ceiling is not strong enough at the suspension
point, the installer must provide strengthening using suitable plates
and backing pieces anchored to the structurally sound parts.
INSTALLATION INSTRUCTIONS
�
�
� �