Download Print this page

Advertisement

GM
Operator Manual

Advertisement

loading
Need help?

Need help?

Do you have a question about the GM and is the answer not in the manual?

Questions and answers

Tim
February 4, 2025

how do i change wash temperature for glass washer GM serial number 150793

Summary of Contents for Starline GM

  • Page 1 Operator Manual...
  • Page 2: Table Of Contents

    • tel (03) 9518 3888 • Fax (03) 9518 3818 • Web www.moffat.com.au Service 0800 782 754 m2 High performance passthrough Dishwasher - Operator Manual Parts 09 829 0930 Manufactured in New Zealand by Washtech Ltd. 414 Rosebank Road, Avondale, Auckland 1026. PO BOX 90548, Auckland 2 GM - Operator Manual 150624...
  • Page 3: Safety Instructions

    • Power Cord Replacement • If the supply cord is damaged, it must be replaced by the manufacturer or its ser- vice agent or a similar qualified person in order to avoid a hazard 3 GM - Operator Manual 150624...
  • Page 4: Installation Checklist

    High performance passthrough Dishwasher - Operator Manual Troubleshooting Installation • If machine doesn’t fill after switching on power, check & ensure that hot water supply tap is open, water supply pressure is not below specification. 4 GM - Operator Manual 150624...
  • Page 5: Installation Diagram

    GM Installation Diagram GM INST 08-12-14 3A 5 GM - Operator Manual 150624...
  • Page 6 GM Machine Operation Turn machine on at wall. Fit scrap tray, filter, upstand and shut door. Press On/Off Key for 3 Seconds Start key glows white as machine fills. If door is open then the start key glows purple Once full, rinse heating starts. Start key glows orange while heating.
  • Page 7: Operating Procedures

    Cycle times are short and water consumption per cycle low – so there is no advantage in overloading racks. CYCLE TIMES The GM has a 1, 2, 3 minute cycle and extended manual cycle. CHEMICAL Correct type and quantity of detergent is essential for good results. Use good quality chemicals and regularly check containers.
  • Page 8: Troubleshooting

    Check flow rate of water supply Check water supply Drain Failure Drain hose jammed/blocked Check/unblock drain hose Drain upstand not removed Remove upstand before draining If the error message remains call for service 8 GM - Operator Manual 150624...
  • Page 9 Pre-rinse, change wash water regularly Not drying Poor wash/rinse performance Refer above Low temperatures Check heating systems Drying agent not used Use quality drying agent/rinse fluid Foaming Wash Excessive Rinse Fluid Adjust Rinse Fluid 9 GM - Operator Manual 150624...
  • Page 10 GM7(S) Wiring Diagram 060248 19/06/15 1 B GM7(S) WIRING DIAGRAM IMPORTANT    10 GM - Operator Manual 150624...
  • Page 11 Accessories Code Description 600 70080 Cuprack 450mm 600 70081 Dishrack 450mm C660503 G Cutlery Container 11 GM - Operator Manual 150624...
  • Page 12 Manufactured in New Zealand by Washtech Ltd. 414 Rosebank Road Avondale Auckland 1026 New Zealand PO Box 90548, Auckland 24HR Service 0800 Starline 09 829 0930 09 829 0935 E-mail info@washtech.co.nz www.starline.co.nz ISO9001 All Washtech products are designed and...
Save PDF