Information supplied in this manual is copyright. No part of this work may be reproduced or copied in any form or by any means, electronic or mechanical without the express permission of the author / publisher. 25/09/2018 Washtech CDe120 Operator Manual...
Installation and servicing must be carried out by a suitably qualified person in compliance with all local codes and standards including AS/NZS 3500.1. 25/09/2018 Washtech CDe120 Operator Manual...
NOTE: Above this range fit an approved pressure limiter. Below this range fit a rinse booster pump. Do not use small diameter plastic supply lines • Backflow prevention: Watermark approved Atmospheric Vacuum Breaker (AVB) fitted standard. Watermark Certification #08603 25/09/2018 Washtech CDe120 Operator Manual...
Page 7
Chemical Detergent and rinse aid pumps are not supplied with the CDe120. We recommend you • consult your chemical supplier and/or a local chemical expert for their recommended detergent and Rinse Fluid injector pumps.
USE LONG CYCLE WHERE POSSIBLE DRAINING THE MACHINE DRAIN THE MACHINE DAILY SHUT-DOWN AND DAILY CLEANING CHECK WASH ELEMENTS HAVE COOLED BEFORE CLEANING WEEKLY MAINTENANCE FULL MACHINE CLEAN INCLUDING WASH/RINSE ARMS PLANNED SERVICNG IMPORTANCE OF HAVING MACHINE SERVICED REGULARLY 25/09/2018 Washtech CDe120 Operator Manual...
Machine stops and refills during the commissioning stage • Fit the curtains according to the Operator Care – curtain diagram (page 13). • Ensure the Scrap Trays are fitted in the Wash and Rinse Zones. 25/09/2018 Washtech CDe120 Operator Manual...
Scrape and/or rinse trays, plates & glasses in cool water Chemical Use a good quality non foaming commercial detergent and drying agent – do not use domestic detergents which will cause the machine to foam 25/09/2018 Washtech CDe120 Operator Manual...
Flush Arms (1 & 2) with water. Use a toothpick or paper clip if necessary to clear jets. • • Return the Wash Pump Inlet Filter (5), the Drain Upstand (6), Scrap Trays (4), Lower Wash Arms (2) and Upper Wash Arms (1) to the machine. 25/09/2018 Washtech CDe120 Operator Manual...
Flush Arms (7, 8, 9, 10) with water. Use a toothpick or paper clip if necessary to clear jets. • • Return the Rinse Pump Filter (13), Scrap Trays (12), Lower Rinse Arms (9 & 10) and Upper Rinse Arms (7 & 8) to the machine. 25/09/2018 Washtech CDe120 Operator Manual...
Curtains must be placed in their correct positions to work properly. They must also be the correct way around. • Broken curtains need to be replaced promptly. Weekly Cleaning • Remove curtains from hooks • Place each curtain into a dishrack and wash through the machine 25/09/2018 Washtech CDe120 Operator Manual...
** For issues that are likely due to poor water quality (scale building up, filters being required on other kitchen equipment etc.), we recommend you consult a local water specialist prior to calling in a dishwasher technician. IF PROBLEMS PERSIST CONTACT MOFFAT SERVICE ON 1300 264 217 25/09/2018 Washtech CDe120 Operator Manual...
The CDe120 are supplied with Atmospheric Vacuum Breaker as the source of backflow prevention to prevent contamination of supply water as required. These AVBs and associated systems within the CDe120 have been tested and confirmed as compliant with latest WMTS 101:2016 – Appliances (low hazard rating).
Page 20
Manufactured in New Zealand by Washtech Ltd. 414 Rosebank Road Avondale Auckland 1026 New Zealand PO Box 90548, Auckland 24HR Service 0800 Starline 09 829 0930 09 829 0935 E-mail info@washtech.co.nz www.starline.co.nz ISO9001 All Washtech products are designed and...
Need help?
Do you have a question about the CDe120 and is the answer not in the manual?
Questions and answers