Pioneer AVIC-Z120BT Operation Manual page 238

Section
m(
Connecting the System
)
Connecting the power cord (2)
Pink (CAR SPEED SIGNAL INPUT)
7'
The mobile navigation system is connected here to detect the distance the vehicle travels. Always
connect the vehicle's speed detection circuit. Failure to make this connection will increase errors
in the location display.
&WARNING
IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING
elECTRICAL SHOCK. AND INTERFERENCE WITH THE OPERATION OF THE VEHICLE'S ANTI LOCK
BRAKING SYSTEM. AUTOMATIC TRANSMISSION AND SPEEDOMETER INDICATION.
ACAUTION
It is strongly suggested that the speed pulse wire be connected for accuracy of navigation
and better performance.
• Note
The position of the speed detection circuit and the position of the parking brake switch
vary depending on the vehicle model. For details, consult your authorized Pioneer dealer
or an installation professional.
~
- - . J " " , , -
~~
Power supply side
Ground side
7
Clamp the parking brake switch
power supply side lead .
...
Clamp firmly with needle-nosed
pliel's.
Connection method
light green (PARKING BRAKE)
Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply
side of the parking brake SWitch.
If this connection is made incorrectly or omitted, certain functions of your navigation system
will be unusable.
AWARNING - - - - - - - - - - - - - - - - ,
LIGHT GREEN LEAD AT POWER CONNECTOR IS
DESIGNED TO DETECT PARKED STATUS AND MUST
BE CONNECTED TO THE POWER SUPPLY SIDE OF THE
PARKING BRAKE SWITCH. IMPROPER CONNECTION
OR USE OF THIS LEAD MAY VIOLATE APPLICABLE
LAW AND MAY RESULT IN SERIOUS INJURY OR
DAMAGE.
GD
En