Table of Contents
Advertisement
P r o D u c t s e t u P
Wheretoputyourradio
It is important that you consider carefully in advance where
your BEAM Extreme will be situated and make sure that it is:
* on a flat and stable surface
N ote:Never place your BEAM on antique or polished
surfaces��
* within 1��8 metres of a power socket
* where you have good wireless network reception or a LAN
network cable connection
* where you can fully extend the telescopic aerial when
listening to DAB or FM stations��
* away from bright sunlight or heat sources, such as a radiator
* not in a humid or very damp place such as a bathroom
Switchingonandconnectingtoyourwireless
network��
Step1: Connect the mains power lead into the socket on the
back of the BEAM on the right hand side and plug the power
adaptor into the mains power wall socket and switch on��
Step2: 'Magicbox' will be displayed followed by 'Loading������'
The power up sequence for your BEAM product does take
some time so please be patient��
BEAM.indd 8
S tep3: The set up wizard screen will be displayed�� Touch
'YES' on the screen to begin the setup process�� If you make a
mistake you can press the
Step4: Touch the screen to make your selections for
Language, 1 or 4 hour clock, time sync�� source and WLAN
region�� For the UK 'Most of Europe' is normally selected��
S tep5: Your radio will scan for available networks�� Your radio
may find more than one network�� Please touch the screen to
select the network that you would like to connect to�� Please
note that you may need to touch the
to browse all the networks that have been found��
If your network is not configured to request a password
(WEP/WPA), the radio will connect to the network and the
following screen will be displayed:
N ote: You should only connect to wireless access points/
networks that you own or have agreement to use��
8
icon to go back��
or
on the screen
19/9/11 12:44:47
Advertisement
Table of Contents
