Table of Contents
Advertisement
F M M o D e
Telescopicaerial
Please make sure that the aerial on the back of the BEAM is
fully extended and adjusted before you attempt to tune to
an FM station (a vertical position is recommended)�� This will
ensure that the maximum signal strength is available when
the BEAM begins to scan�� Extending the aerial also ensures
the best possible sound quality��
SelectFMmode
1��
T ouch 'FM' on the main menu screen or select 'FM' using the
mode button and the
on the remote control��
When your BEAM is in FM mode it can receive Radio Data
System or 'RDS' information if this is being transmitted by the
broadcaster�� RDS information will often include the station
name, detail about the programme and the current time��
BEAM.indd 18
or
buttons followed by 'Select'
TunetoanFMstation
1�� Touch
on the display and then touch the
scan up or down the frequency band�� The BEAM will stop
each time a station is received��
�� To scan manually for stations, just touch
disable the auto scan function and then touch the
scan up or down the frequency band��
FMmenuoptions
Touch 'FM' at the bottom of the screen in the middle to
access the following further FM menu options:
My presets and edit presets- see saving presets (favourites)
on page 1��
s top on stations - select to stop on 'All' and the scan will stop
for every station it receives, even if the signal strength is poor
or set to stop on those with a 'Strong' signal only��
Force mono - by default all stations are played in stereo but
for weak stations this can result in a poor signal to noise ratio
or hiss�� To improve the sound quality of these stations, set
the Force mono option to 'Yes' ��
18
or
to
again to
or
to
19/9/11 12:44:54
Advertisement
Table of Contents
