Advertisement
12. Connect the two horizontal transport unit con-
nectors to the connectors located at the rear of
the right side of the finisher. Secure the cord with
a cord clamp.
13. Open the finisher front door and pull the lever.
14. Install the finisher on the machine.
Y111090-1
15. Push the lever pulled in step 13 back to its origi-
nal position. Align the mounting hole on the lever
with the screw hole on the finisher, and then
screw the lever to the finisher (one furnished
mounting screw).
Note:
The mounting hole on the lever must overlap with
the screw hole on the finisher.
A0HRIXC028DA
Mounting hole on the
lever
* If the mounting hole on the lever does not overlap
with the screw hole on the finisher, take the fol-
lowing step (1) to (9).
(1) Disconnect the two connectors and remove the
cord clamp. Remove the finisher from the main
body.
A0HRIXC029DA
(2) Remove the lower front cover from the finisher
(two screws).
A0HRIXC030DA
E-5
Screw hole
A0HRIXC031DA
A0HRIXC040DA
A0HRIXC032DA
Installation Manual
Advertisement
