Table of Contents
Advertisement
Open the battery cover of the remote control and put two
AAA size batteries so the '+' and '-' marks on the batteries
match the '+' and '-' marks inside the remote control.
Replace the battery cover.
Switch your TV on and select the correct video input.
Switch the aerialBox ultra on and wait for it to boot up.
The Welcome screen should appear
on your TV*. Press OK to start a scan.
An auto scan will now start, please
do not push any buttons until it has
nnished. Once it has nnished if the
signal from your UHF aerial is good
TV1 will appear and you can start
using your aerialBox Ultra.
* If the Welcome screen does not appear, go to the Menu select Installation then Factory Default. The default
pin/password is 0000.
Please make sure you don't have a USB device plugged in while going through the setup process.
Once you are setup you can then plug your device in.
7
Advertisement
Table of Contents
